- Iexplorer registration code for veersion 4.1.3.6 serial#
- Iexplorer registration code for veersion 4.1.3.6 upgrade#
- Iexplorer registration code for veersion 4.1.3.6 full#
- Iexplorer registration code for veersion 4.1.3.6 software#
Iexplorer registration code for veersion 4.1.3.6 serial#
Connect locally to JACE via serial debug port.Workaround steps for JACE failing to start: Otherwise, if the JACE has failed to start due to this issue, then a workaround step is to use the serial console to temporarily reset the time which will allow the JACE to restart properly and be commissioned.
Iexplorer registration code for veersion 4.1.3.6 upgrade#
If the JACE is running Niagara 4.1 or earlier, then the recommended remedy is to upgrade to a newer version that is not affected. If the issue occurs and prevents boot-up, then the terminal output will look like this:
Iexplorer registration code for veersion 4.1.3.6 software#
The affected code has remained in software files used only for recovery of the flash partition to factory default.
Please note that the normal first-time power-up of new JACE 8000 hardware in 2021 is not a problem. JACE controllers commissioned with Niagara 4.2 or above should operate normally unless they are reset to factory default via the two methods listed below, or if the AX-to-N4 conversion process is executed. If an affected device fails to reboot after January 1, 2021, then use the workaround step described below prior to commissioning.Inform commissioning and maintenance engineers of additional steps to avoid unnecessary field returns.As a precaution, customers running Niagara 4.2 through 4.8 should obtain updated cleanDist and conversion files via the links below and copy to their Niagara Workbench software, thus avoiding any future issues when cleanDist or conversion action is required.Systems running Niagara 4.0 and 4.1 should be upgraded to avoid the issue.If an upgrade is not feasible at this time, then all systems should be upgraded immediately to Niagara 4.4. Systems running on a JACE 3, 6 & 7 should be upgraded to a JACE 8000 at 4.9.
Iexplorer registration code for veersion 4.1.3.6 full#
Here is the full list of actions to address this issue: Nevertheless, we recommend that any customer running Niagara 4.2 through 4.8 take certain actions as a precaution. Please note, systems running Niagara 4.2 and above are not affected by this issue. The scenarios that are known to trigger the issue are described in more detail below. The issue has been observed in the process of cleaning storage drives and converting software from Niagara AX to N4. It has been reported that JACE 3, 6, 7 Series as well as JACE 8000 controllers can, in some scenarios, fail to reboot as expected post-January 1, 2021.